ABB ACS880 Series, Firmware Manual

Page: 577 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
- / real32 Displays the temperature measured through the sensor
input of interface module 2. The unit (°C or °F) is
selected by parameter
96.16 Unit selection .
Note: With a PTC sensor, the unit is ohms.
Note: This parameter is read-only.
Module 2
temperature 91.6
- / - Temperature measured through interface module 2. 0.0 ... 1000.0 °C
Done / uint16 Validates any changed encoder interface module
parameters. This is needed for any parameter changes
in groups 90…93 to take effect.
After refreshing, the value reverts automatically to
Done .
• Permanent magnet motors only: The drive will
perform a fresh autophasing routine (see page
102 ) at next start if the motor feedback encoder
settings have been changed.
• The parameter cannot be changed while the drive
is running.
Encoder parameter
refresh 91.10
0 Refreshing done. Done
1 Refreshing. Refresh
None / uint16 Defines the type of the module used as interface
module 1. Module 1 type 91.11
0 None (communication disabled). None
1 FEN-01. FEN-01
2 FEN-11. FEN-11
3 FEN-21. FEN-21
4 FEN-31. FEN-31
5 FSE-31. FSE-31
2 / uint16 Specifies the slot (1…3) on the control unit of the drive
into which the interface module is installed.
Alternatively, specifies the node ID of the slot on an
FEA-03 extension adapter. Module 1 location 91.12
1 = 1 / 1 = 1 Slot 1 = 1; Slot 2 = 2; Slot 3 = 3
4…254: Node ID of the slot on the FEA-03 extension
adapter 1...254
None / uint16 Defines the type of the module used as interface
module 2. Module 2 type 91.13
0 None (communication disabled). None
1 FEN-01. FEN-01
2 FEN-11. FEN-11
3 FEN-21. FEN-21
4 FEN-31. FEN-31
5 FSE-31. FSE-31
Parameters 577