ABB ACS880 Series, Firmware Manual

Page: 209 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
1 = 1 = 1 0000h…FFFFh
Drive not ready /
unit32 Displays the current state of drive control. Drive control state 9.9
0 Drive is not ready for operation. Drive not ready
1 No motor ID run done. Necessary to run in DTC mode. ID run undone
2 Drive is stopped. Drive stopped
3 A fault is active. Fault active
4 Drive is in Local control. Local control
5 Jogging enable signal is On. Jog mode
6 Control location EXT1 is active. Ext1 running
7 Control location EXT2 is active. Ext2 running
8 Drive is stopping the motor as per deceleration ramp
time settings. Stopping
9 Stopping after receiving an emergency stop command. Em stop active
10 Drive is running in constant speed mode. Constant speed
0.00 A / real32 Displays actual drive output current. Drive output current 9.11
100 = 1 A / 100 = 1 A Drive output current. 0.00 ... 30000.00 A
0.00 A / real32 Displays the actual motor current estimate based on
transformer ratio and sine-filter settings. Motor current
estimated 9.13
100 = 1 A / 10 = 1 A Estimated motor current. 0.00 ... 30000.00 A
0.00% / real32 Displays estimated actual motor current in %. Motor current % 9.14
100 = 1% / 10 = 1% Estimated motor current. 0.00 ... 30000.00%
0.00 V / real32 Displays the actual motor voltage estimate based on
transformer ratio setting. Motor voltage
estimated 9.15
100 = 1 V / 10 V Estimated motor voltage. 0.00 ... 30000.00 V
0.00 Hz / real32 Displays the frequency reference currently produced
by the ESP control program. Frequency reference
used 9.21
100 = 1 Hz / 10 = 1 Hz ESP frequency. -600.00 ... 600.00 Hz
0.00% / real32 Displays ESP speed/frequency reference in percent
scale. Speed reference
percentage 9.22
100 = 1% / 10 = 1% Speed reference. -1200.00 ...
1200.00%
0.00 rpm / real32 Displays the speed reference currently produced by the
ESP control program. Speed reference
used 9.23
10 = 1 rpm / 10 = 1
rpm Speed reference. -30000.0 ... 30000.0
rpm
0.00 min / real32 Displays the time remaining before restart delay
function stops inhibiting the user start command. Restart delay
remaining 9.41
10 = 1 min / 10 = 1
min Restart delay time. 0.0 ... 30000.0 min
Parameters 209