ABB ACS880 Series, Firmware Manual

Page: 26 / 764

WARNING! Make sure that the machinery into which the drive with
brake control function is integrated fulfills the personnel safety
regulations. Note that the frequency converter (a Complete Drive
Module or a Basic Drive Module, as defined in IEC 61800-2), is not
considered as a safety device mentioned in the European Machinery
Directive and related harmonized standards. Thus, the personnel safety
of the complete machinery must not be based on a specific frequency
converter feature (such as the brake control function), but it has to be
implemented as defined in the application specific regulations.
Start-up
Safety
WARNING!
The start-up may only be carried out by a qualified electrician.
The safety instructions must be followed during the start-up procedure. See the safety
instructions on the first pages of the appropriate
Hardware manual.
Check the installation. See the installation checklist in the appropriate Hardware
manual.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if
•
there is a risk of damage in case of an incorrect direction of rotation, or
• a Normal ID run is required during the drive start-up, when the load torque is higher
than 20% or the machinery is not able to withstand the nominal torque transient
during the ID run.
1 – Power-up, date and time settings
Power up the drive.
Note: It is normal that warning messages
appear at various points along the start-up
process. To hide a message and to resume
the start-up process, press
.
Hide any warnings now to enter the Home
view (shown on the right).
The two commands at the bottom of the
display (in this case, Options and Menu),
show the functions of the two softkeys
and
located below the display. The com-
mands assigned to the softkeys vary depend-
ing on the context.
26 Quick start-up guide