ABB ACS880 Series, Firmware Manual

Page: 308 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
Not selected / uint32 Selects the source of motor potentiometer up signal.
0 = No change
1 = Increase motor potentiometer value. (If both the up
and down sources are on, the potentiometer value will
not change.) Motor
potentiometer up
source 22.73
0 0 Not selected
1 1 Selected
2 Digital input DI1 ( 10.2 DI delayed status , bit 0). DI1
3 Digital input DI2 ( 10.2 DI delayed status , bit 1). DI2
4 Digital input DI3 ( 10.2 DI delayed status , bit 2). DI3
5 Digital input DI4 ( 10.2 DI delayed status , bit 3). DI4
6 Digital input DI5 ( 10.2 DI delayed status , bit 4). DI5
7 Digital input DI6 ( 10.2 DI delayed status , bit 5). DI6
10 Digital input/output DIO1 ( 11.2 DIO delayed status , bit
0).
DIO1
11 Digital input/output DIO2 ( 11.2 DIO delayed status , bit
1).
DIO2
See Terms and abbreviations (page 169) . Other [bit]
Not selected / uint32 Selects the source of motor potentiometer down signal.
0 = No change
1 = Decrease motor potentiometer value. (If both the
up and down sources are on, the potentiometer value
will not change.)
For the selections, see parameter
22.73 Motor
potentiometer up source .
Motor
potentiometer down
source 22.74
60.0 s / real32 Defines the change rate of the motor potentiometer.
This parameter specifies the time required for the
motor potentiometer to change from minimum (
22.76 )
to maximum ( 22.77 ). The same change rate applies in
both directions.
Motor
potentiometer ramp
time 22.75
10 = 1 s / 10 = 1 s Motor potentiometer change time. 0.0 ... 3600.0 s
-1500.00 / real32 Defines the minimum value of the motor potentiometer. Motor
potentiometer min
value 22.76
1 = 1 / 100 = 1 Motor potentiometer minimum. -32768.00 ...
32767.00
1500.00 / real32 Defines the maximum value of the motor
potentiometer. Motor
potentiometer max
value 22.77
1 = 1 / 100 = 1 Motor potentiometer maximum. -32768.00 ...
32767.00
- / real32 Displays the output of the motor potentiometer
function. (The motor potentiometer is configured using
parameters
22.71 … 22.74 .)
This parameter is read-only.
Motor
potentiometer ref
act 22.80
308 Parameters