ABB ACS880 Series, Firmware Manual

Page: 604 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
1 Factory macro (see 150 ). Factory
2 Hand/Auto macro (see page 152 ). Hand/Auto
3 PID control macro (see page 155 ). PID-CTRL
4 Torque control macro (see page 160 ). T-CTRL
5 Sequential control macro (see page 163 ). Sequence control
6 Reserved.
Factory / uint16 Shows which application macro is currently selected.
To change the macro, use parameter
96.4 Macro select .
Macro active 96.5
1 Factory macro (see 150 ). Factory
2 Hand/Auto macro (see page 152 ). Hand/Auto
3 PID control macro (see page 155 ). PID-CTRL
4 Torque control macro (see page 160 ). T-CTRL
5 Sequential control macro (see page 163 ). Sequence control
6 Reserved.
Done / uint16 Restores the original settings of the control program,
i.e. parameter default values.
Note: This parameter cannot be changed while the
drive is running.
Parameter restore 96.6
0 Restoring is completed. Done
8 All editable parameter values are restored to default
values, except
• motor data and ID run results
• parameter 31.42 Overcurrent fault limit
• control panel/PC communication settings
• I/O extension module settings
• fieldbus adapter settings
• encoder configuration data
• application macro selection and the parameter
defaults implemented by it
• parameter 95.21 HW options word 2
• parameter 95.9 Switch fuse controller
• differentiated defaults implemented by
parameters
95.20 HW options word 1 and 95.21
HW options word 2
• user lock configuration parameters
96.100 … 96.102 .
Restore defaults
604 Parameters