ABB ACS320 series, User Manual

Page: 66 / 442

66 Start-up
Operating the drive
AUTO/HAND – The very first time the drive is powered up, it is in the auto control
(AUTO) mode, and is controlled from the Control terminal block X1.
To switch to hand control (HAND) and control the drive using the control panel, press
and hold the
or button.
• Pressing the HAND button switches the drive to hand control while keeping the
drive running.
• Pressing the OFF button switches to hand control and stops the drive.
To switch back to auto control (AUTO), press and hold the button.
Hand/Auto/Off – To start the drive press the HAND or AUTO buttons, to stop the
drive press the OFF button.
Reference – To modify the reference (only possible if the display in the upper right
corner is in reverse video) press the UP or DOWN buttons (the reference changes
immediately).
The reference can be modified in the local control mode, and can be parameterized
(using
Group 11: Reference select ) to also allow modification in the remote control
mode.
Note: The Start/Stop, Shaft direction and Reference functions are only valid in local
control (LOC) mode.

Parameters mode
To change the parameters, follow these steps:
1
Select MENU to enter the main
menu.
2
Select PARAMETERS with the
UP/DOWN buttons, and select
ENTER to select the Parameters
mode.
3
Select the appropriate parameter
group with the UP/DOWN
buttons and select SEL
0 A
0 %
0 mA 0.
0.
0.
0.0Hz OFF
MENU
SP
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
1 OFF MAIN MENU
99 START-UP DATA
01 OPERATING DATA
03 FB ACTUAL SIGNALS
04 FAULT HISTORY
10 START/STOP/DIR
PAR GROUPS 99
EXIT SEL
OFF