A&D RA3100 Omniace, Instruction Manual

Page: 112 / 176

9.Using Optional Modules - 9.4.16 Channel Logic Module (RA30-105)
112 1WMPD4004444
Step 2. Set Threshold value (7) according to the target for measurement.
1.4 V, 2.5 V, or 4 V can be selected as the threshold for voltage input.
The resistance value between contacts is used as the threshold for contact connection, as
indicated in the table. Select the setting using the threshold when open.
Non-voltage contact closed
(ON)
H level 250 Ω or lower 1.5 kΩ or lower 3.0 kΩ or lower
Non-voltage contact open
(OFF)
L level 2.0 kΩ or higher 5.0 kΩ or higher 9.0 kΩ or higher
*
A load current of about 0.5 mA flows.
Step 3. Set the channel for monitor display or printer recording in Display signal (10).
Step 4. Set Disp. pos. (8) and Disp. range (9).
9.4.4. Reference Materials
1 Pin layout of input connector
This module can input 16 channels, but eight channels are grouped in CHA and CHB, respectively.
The input, trigger, and waveform display settings are set separately for CHA and CHB.
The connectors are also separate for CHA and CHB.
CHA connector CHB connector
Pin
number Sig name
Pin
number Sig name
Pin
number Sig name
Pin
number Sig name
A1 +5VA2 B1
AGND
A1 +5VA2 B1
AGND
A2 +5VA2 B2 A2 +5VA2 B2
A3 CH8 B3 A3 CH8 B3
A4 CH7 B4 A4 CH7 B4
A5 CH6 B5 A5 CH6 B5
A6 CH5 B6 A6 CH5 B6
A7 CH4 B7 A7 CH4 B7
A8 CH3 B8 A8 CH3 B8
A9 CH2 B9 A9 CH2 B9
A10 CH1 B10 A10 CH1 B10
*
Connector for input signal: DF02R020NA3 (Japan Aviation Electronics Industry)
*
The A series and B series are complementary. AGND (B series) is the input common for A series
signals.
*
AGND is shared with input terminals inside the module.
*
AGND is isolated from the main unit frame (GND).
*
The plugs (manufacturer model numbers) corresponding to each input signal connector are
indicated below.
Compatible plug: DF02P020F22A1 (soldered type), DF02P020G28A1 (pressure connected type)