A&D RA3100 Omniace, Instruction Manual

Page: 34 / 176

2.Pre-Measurement Procedures - 2.2.Turning the Power On/Off
34 1WMPD4004444
2.2.4. Setup Date and Time
The current time is displayed on the top right of the screen, but if it
differs greatly from the actual time, the time can be adjusted.
See "8.2.5 . Environment Setup ".
Time
2.2.5. Preparing for More Precise Measurements
Warm up the product for about 60 minutes after turning on the power in order to perform more precise
measurements.
After the warm up is complete, perform "
Zero adjust " of the input modules.
See "4 Setup Measurement ". This completes the preparations for measurement.
2.2.6. Turning Off the Power
Step 1. When the Power key on the operation panel is pressed
while the power is on, the shut down process starts and the
[Shut down] dialog box indicated below is displayed on the
center of the screen. Tap the OK key to shut down the
product. Tap the Cancel key to continue without turning off
the power.
If the Power key is pressed again while the [Shut down]
dialog box is displayed, the product automatically shuts down.
CAUTION
Make sure to shut down the product to turn off the power, as directly removing the power cable from
the power outlet without shutting down can damage the files in the internal storage.