A&D RA3100 Omniace, Instruction Manual

Page: 28 / 176

2.Pre-Measurement Procedures - 2.1.Before Switching On the Power
28 1WMPD4004444
Step 2. Open the printer cover by raising the lever of the printer block.
Pull the lever upwards.
Recording paper guide (the U-shaped groove)
Platen roller (black roller)
Recording paper outlet
Step 3. Load the paper following the guide of the product, and press
the paper holders into the guide until a click is heard.
NOTE
Be sure the paper roll is loaded so that the thermally sensitive
side is faced toward you; if this side is faced away, the paper
cannot be printed.
If the recording paper is not loaded securely, printing problems
may occur or the recording paper may meander.
Check the winding direction carefully
Push it in so that the thermally sensitive side is faced up
Insert the paper holders into the guide of the printer block
Step 4. Feed the recording paper to the recording paper outlet.
Insert the recording paper from above the platen roller of
the printer block (black roller) from the recording paper
outlet of the printer cover and pull it out about 10 cm.
Step 4-1. Feed the paper to the recording paper outlet from above
the platen roller.
Step 4-2. Pull the recording paper out from the recording paper outlet
about 10 cm.
Recording paper Platen roller
Step 5. Close the printer cover.
After pulling the paper, close the cover firmly pressing
down on both sides (until a click is heard). Pull the
paper out keeping it straight. When using without both
sides of the paper pushed into the recording section,
recording cannot be performed correctly.