A&D RA3100 Omniace, Instruction Manual

Page: 104 / 176

9.Using Optional Modules - 9.2.Four Channel Voltage Module (RA30-102)
104 1WMPD4004444
Disp. range: The display width in the amplitude direction of the waveform display area on the
waveform monitor
Disp. pos.: Specify the position of the waveform monitor to display the specified range of the
waveform display area.
Step 5 Set the display minimum and display maximum.
See the description in "4.2.2. Set the input channels - Display Range and Display Position (Display
Area) ".
Disp. max: Set the display upper limit value of the top of the display range.
Disp. min: Set the display lower limit value of the bottom of the display range.
Step 6. Execute zero adjust.
After turning on the power, changes in the surrounding temperature as time elapses change the
internal temperature of the RA3100 main unit, and cause temperature drift inside the input module,
which leads to errors in measurements due to variation in the DC offset voltage. Execute zero
cancellation to minimize these errors.
To perform zero cancellation, tap the Zero adjust key (14) after waiting for a warm-up period of
60 minutes.
NOTE
This function is for canceling internal offset and drift, and does not cancel the offset of the input signal.
9.2.4. Reference Materials
CAUTION
Ensure that the voltage between each input and the chassis (GND) and between each channel does
not exceed 300 V AC or DC. (Damage may be caused if the voltage is exceeded.)
1 Input cable
The input connectors for CH1 to CH2 are insulated BNC connectors. Do not connect metallic BNC
plugs, as they may damage the connectors or cause connection problems.
Use the insulated BNC cable indicated below (RA30-507) as the signal input cables.
Recommended cables
Name (type) Shape/characteristics Remarks
Insulated BNC cable
(safety alligator clip)
RA30-507
M
AXI
M
U
M
R
AT
ED
VO
LT
AG
E
T
O
EA
RT
H
M
AXI
M
U
M
R
AT
ED
LIN
E
VO
LT
AG
E
C
AT
Ⅲ
30
0V
C
AT
Ⅱ
60
0V
60
0V
RA
30
-50
7
!
Insulated BNC
Safety alligator clip
Red +
Black -
Length 1.5 m + 0.2 m
RA30-101
RA30-102
RA30-103
Analog input