Siemens SINAMICS G120XA, Руководство по эксплуатации

Страница: 99 / 918

Setting Parameter Characteristics Setting Parameter
Default setting
55
p0015 = 55
$,
Q
PLQ
PLQ
9 9 9
Q
$2
P$
P$
PLQ
PLQ
,
$2
P$
P$
$ $
DI 0
ON/OFF1
OFF2
DI 1
DI 4
DI 5
p29652[1] = 722.0
p29650[1] = 0
p0840[0...1] =
29659.0
p0844[0...1] =
29659.1
p29652[0] = 722.1
p29650[0] = 1
p0810 = 722.4
p2104[0...1] = 722.5
AI 0 p1070[1] =
755[0]
AO 0 p0771[0] = 21
AO 1 p0771[1] = 27
USS p2020 = 8
p2023 = 4
p2030 = 1
p2040 = 65000
p1070[0] =
2050[1]
p0854[0] =
2090.10
DO 0
DO 1
DO 2
DO 3
p0730 = 52.3
p0731 = 52.2
p0732 = 52.1
p0733 = 52.7
Procedure with the BOP-2 operator panel:
→ SETUP → … → MAc PAr → P15 = X USSl-r → … → FINISH
Further information
The default terminal settings can be adjusted to suit your requirements.
Adapt the default setting of the terminal strips (Page 129)
4.2.6 Terminal strip X9 (FSH/FSJ only)
Terminal strip X9 is used to connect an external 24 V DC power supply and to connect a main
or bypass contactor.
To access terminal strip X9, you must first remove the front cover from the converter.
Connecting inverters (Page 68)
Fault and alarm signals can be connected to the digital inputs.
The external 24 V DC power supply must be connected if the converter is connected to the line
supply via a main contactor (to start the Control Unit).
The power supply should be located directly next to the converter (e.g. in the same cabinet) and
the cable length to terminal strip X9 should not exceed 5 m.
Note
Inputs are low active.
All signal inputs are low active (wire-break-proof).
Wiring
4.2 Control interfaces
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
97