Siemens SINAMICS G120XA, Руководство по эксплуатации

Страница: 603 / 918

07 Speed setpoint - actual value deviation in tolerance t_off Yes No 8011
08 I_act >= I_threshold value p2170 Yes No 8022
09 Vdc_act <= Vdc_threshold value p2172 Yes No 8022
10 Vdc_act > Vdc_threshold value p2172 Yes No 8022
11 Output load is not present Yes No 8022
13 |n_act| > n_max (F07901) Yes No -
NOTICE
For bit 06:
When the overspeed is reached, this bit is set and F07901 output immediately following this. The bit is canceled again
as soon as the next pulse inhibit is present.
Note
For bit 00:
The threshold value is set in p1080 and the hysteresis in p2150.
For bit 01, 02:
The threshold value is set in p2155 and the hysteresis in p2140.
For bit 03:
1 signal direction of rotation positive.
0 signal: direction of rotation negative.
The hysteresis is set in p2150.
For bit 04:
The threshold value is set in r1119 and the hysteresis in p2150.
For bit 05:
The threshold value is set in p1226 and the delay time in p1228.
For bit 06:
The hysteresis is set in p2162.
For bit 07:
The threshold value is set in p2163 and the hysteresis is set in p2164.
For bit 08:
The threshold value is set in p2170 and the delay time in p2171.
For bit 09, 10:
The threshold value is set in p2172 and the delay time in p2173.
For bit 11:
The threshold value is set in p2179 and the delay time in p2180.
For bit 13:
Only for internal Siemens use.
r2198.4...12 CO/BO: Status word monitoring 2 / ZSW monitor 2
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 2536
Min:
- Max:
- Factory setting:
-
Description: Display and BICO output for the second status word of the monitoring functions.
Bit field: Bit Signal name 1 signal 0 signal FP
04 |n_set| < p2161 Yes No 8011
05 n_set > 0 Yes No 8011
06 Motor blocked Yes No 8012
07 Motor stalled Yes No 8012
08 |I_act| < I_threshold value p2170 Yes No 8022
11 Load in the alarm range Yes No 8013
12 Load in the fault range Yes No 8013
Parameters
7.3 Parameters
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
601