Rohde & Schwarz FPL1000 Series, Руководство пользователя

Страница: 689 / 899

Remote Commands
R&S
®
FPL1000
689 User Manual 1178.3370.02 ─ 03
Example: INIT:CONT OFF
Switching to single sweep mode.
SWE:COUN 16
Sets the number of measurements to 16.
DISP:TRAC3:MODE WRIT
Selects clear/write mode for trace 3.
INIT;*WAI
Starts the measurement and waits for the end of the measure-
ment.
Manual operation: See " Trace Mode " on page 467
DISPlay[:WINDow<n>]:TRACe<t>:MODE:HCONtinuous <State>
This command turns an automatic reset of a trace on and off after a parameter has
changed.
The reset works for trace modes min hold, max hold and average.
Note that the command has no effect if critical parameters like the span have been
changed to avoid invalid measurement results
Suffix:
<n>
.
Window
<t> Trace
Parameters:
<State> ON | 1
The automatic reset is off.
OFF | 0
The automatic reset is on.
*RST:
0
Example: DISP:WIND:TRAC3:MODE:HCON ON
Switches off the reset function.
Manual operation: See " Hold " on page 468
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command turns a trace on and off.
The measurement continues in the background.
Suffix:
<n>
.
Window
<t> Trace
Parameters:
<State> ON | OFF | 1 | 0
*RST:
1 for TRACe1, 0 for TRACe 2 to 6
Example: DISP:TRAC3 ON
Setting Basic Spectrum RF Measurement Parameters