Rohde & Schwarz FPL1000 Series, Руководство пользователя

Страница: 594 / 899

Remote Commands
R&S
®
FPL1000
594 User Manual 1178.3370.02 ─ 03
Parameters:
<Frequency> Numeric value.
*RST:
-12.75 MHz (range 1), -2.515 MHz (range 2), 2.515
MHz (range 3)
Default unit: Hz
Manual operation: See " Range Start / Range Stop " on page 332
[SENSe:]LIST:RANGe<range>[:FREQuency]:STOP <Frequency>
This command defines the stop frequency of a spurious emission measurement range.
Make sure to set an appropriate span. If you set a span that is
●
smaller than the span the sweep list covers, the R&S FPL1000 will not measure
the ranges that are outside the span - results may be invalid.
●
greater than the span the sweep list covers, the R&S FPL1000 will adjust the start
frequency of the first range and the stop frequency of the last range to the span
For more information see Chapter 7.2.7, "Spurious Emissions Measurement" ,
on page 327 .
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<Frequency> Numeric value.
*RST:
-2.52 MHz (range 1), 2.52 MHz (range 2), 250.0
MHz (range 3)
Default unit: Hz
Manual operation: See " Range Start / Range Stop " on page 332
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation <Attenuation>
This command defines the input attenuation for a spurious emission measurement
range.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<Attenuation> Numeric value.
Refer to the data sheet for the attenuation range.
*RST:
10 dB
Default unit: dB
Manual operation: See " RF Attenuation " on page 334
Configuring and Performing Measurements