Pacific Power Source LMX Series, Руководство по эксплуатации

Страница: 257 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 257 of 463
Command Syntax [SOURce:]CURRent:PROTect:LEVel
Description This command sets the programmable current trip level for all
phases. The value set cannot exceed the maximum current capability
of the power source as returned by the
“ [SOURce:]CURRent:LIMit#:MAX?” command.
If the load current exceeds the current trip set point, the source will
turn off its output after the “ CURRent:PROTect:TOUT ” delay time
outs and generate a fault message.
Parameters 0.00 – MAX
Parameter Format <nr2>
Example CURR:PROT:LEV 24.0000
Query Format [SOURce:]CURRent:PROTect:LEVel?
Returned Data Format <nr2>
Query Example CURR:PROT:LEV?
24.0000
Command Syntax [SOURce:]CURRent:OVerload
Description This command turns the overload current mode on or off
Parameters [ 0 | OFF | 1 | ON ]
Parameter Format <b>
Example SOUR:CURR:OV ON
Query Format [SOURce:]CURRent:OVerload?
Returned Data Format <b>
Query Example CURR:OV?
1
Command Syntax [SOURce:]IPROTect:STATe
Description This command turns the current protection mode on or off
Parameters [ 0 | OFF | 1 | ON ]
Parameter Format <b>
Example IPROT:STAT ON
Query Format [SOURce:]IPROTect:STATe?
Returned Data Format <b>
Query Example IPROT:STAT?
1
Query Format [SOURce:]IPROTect:TRIPped?
Description This command returns the current protection state. If the peak
current protection has been tripped, a 1 is returned.
Returned Data Format <b>
Query Example IPROT:TRIP?
0