Pacific Power Source LMX Series, Руководство по эксплуатации

Страница: 266 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 266 of 463
Command Syntax [SOURce:]WAVEFORM#:NAME
Description Set waveform for selected phase to the waveform name passed as a
parameter. If no waveform name parameter is specified, the query
format returns the name of the selected waveform. See
WAVEFORM#[:NAME] command.
Parameters 1 – 16
Parameter Format <nr1>
Example WAVEFORM1 4
Query Format [SOURce:]WAVEFORM#:NAME?
Returned Data Format <nr1>
Query Example SOUR:WAVEFORM1?
4
Command Syntax [SOURce:]WAVEFORM#:ALIAS
Description Analogous to the WAVEFORM#[:NAME] command but in place of the
waveform name, the waveform description is passed as a quoted
string.
Parameters Waveform description as quoted string.
Parameter Format <cr>
Example WAVEFORM1:NAME:BYALIAS “Triangle”
Query Format [SOURce:]WAVEFORM#:ALIAS?
Description Analogous to the WAVEFORM#[:NAME]? query command but in
place of the waveform name, the alias is returned as a string.
Returned Data Format <cr>
Query Example WAVEFORM1:ALIAS?
Triangle
Command Syntax
[SOURce:]WAVEFORM#:LOAD
Description Sets the waveform name (1 – 16) to be loaded for the selected phase
# for the next SWITCH command. If # is omitted, sets all available
phases to waveform name specified.
Note: The waveform LOAD command loads the selected phase’s
waveform registers with the waveform data for the specified
waveform name but does not cause it to appear at the output until
the WAVEFORM:SWITCH command is received.
Parameters 1 – 16
Parameter Format <nr1>
Example WAVEFORM2:LOAD 12
Query Format [SOURce:]WAVEFORM#:LOAD?
Returned Data Format <nr1> or <nr1>,<nr1>,nr1>
Query Example WAVEFORM:LOAD?
1,12,1