Pacific Power Source LMX Series, Руководство по эксплуатации

Страница: 89 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 6:
Front Panel Operation
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 89 of 463
6.1.1 Keyboard Buttons
There are several groupings of push buttons that make up the front panel. They are grouped
as follows:
Group Function
Menu Selection Keys These keys select the available top-level menus. Sub menus may be
accessible using any of the available soft keys within each top-level
menu.
Soft Keys Soft keys change function as indicated by the decal directly to the
left of the soft key on the LCD display.
Shuttle See next section for details on shuttle operation.
Decimal Key Pad The decimal key pad is used to enter parameter values directly.
Values may also be set using any available soft key or the shuttle.
ENTER Key The ENTER key confirms a selection or setting made with the
decimal key pad. Until confirmed by pressing the ENTER key,
selections and values will be shown grayed out on the LCD display
to indicate they have been edited/changed but have not yet taken
effect. This allows multiple parameters in the same screen to be
edited with all new setting values taking effect at once when the
ENTER or UPDATE ALL soft key is pressed.
ESC Key The escape key backs out of a menu or selection and returns to a
previous level.
Back Space Key (

)
This key backs up one position erasing the last digit value entered.
OUTPUT ENABLE
The
OUTPUT ENABLE
key is used to toggle the output on or off. If
the output is ON, this key will be lit.
LOCAL Returns the instrument to local control mode allowing front panel
operation. This key may be disabled over one of the remote control
interfaces. While in REMOTE, the keyboard is locked out.
The LOCAL key can also be used to capture and LCD Image and
store it as an .png image file in internal memory. To do so press and
hold the LOCAL key, then press the 1 key. Screen images are saved
in folder “internal/screenshots”.
PHASE The PHASE key is used to select a specific phase on three phase
LMX ––models. On single phase LMX models, the selected phase is
always A and this key has no function.
PROGRAM MENU
MEASUREMENTS
TRANSIENTS
UTILITY MENU
HELP SCREENS
OUTPUT ON/OFF
LOCAL KEY
PHASE SELECTION
MENU KEYS LCD DISPLAY SOFT KEYS SHUTTLE KEYPAD ENTER KEY