Pacific Power Source LMX Series, Руководство по эксплуатации, Страница: 258 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 258 of 463
Command Syntax [SOURce:]IPEAK:PROTect:STATe
Description This command enables or disables the user programmable current
protection mode.
Parameters [ 0 | OFF | 1 | ON ]
Parameter Format <b>
Example IPEAK:PROT:STAT 1
Query Format [SOURce:]IPEAK:PROTect:STATe?
Returned Data Format <nr1>
Query Example IPEAK:PROT:STAT?
1
Command Syntax
[SOURce:]IPEAK:PROTect:LEVel
Description This command sets user programmable the peak current protection
mode level.
Parameters 0.0000 – 100000.0000
Parameter Format <nr2>
Example IPEAK:LIM 50.0
Query Format [SOURce:]IPEAK:PROTect:LEVel?
Returned Data Format <nr2>
Query Example IPEAK:PROT:LEV?
50.000
8.7.5 Phase Programming Commands
Command Syntax [SOURce:]PHASe#
Description This command programs the phase angle for the selected phase. A
phase reference (#) must be specified.
Note that unless external sync mode is used, the A phase (# = 1)
cannot be programmed is fixed at 0 degrees.
Parameters 0.0 – 359.9
Parameter Format <nr2>
Example PHAS2 122.5
Query Format [SOURce:]PHASe#?
Returned Data Format <nr2>
Query Example PHAS2?
122.5