Pacific Power Source LMX Series, Руководство по эксплуатации, Страница: 406 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 10:
LAN Interface Configuration
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 406 of 463
Settings and ranges are detailed in the table bellows.
CONTROL Purpose
CHANNEL A
Input Selects output phase and parameter to be captured on Channel A. Available
phase vary by model: (Phase A for Single phase, Phase A or B in Split phase,
Phase A, B or C in Three phase mode.
Attenuator Sets input amplitude scaling from 1V/div to 200V/div. Also available is AUTO
scaling or channel OFF.
DC Offset This setting sets DC Offset or AUTO for auto DC offset compensation.
CHANNEL B Same as Channel A but for B Channel
CURSORS Check Check ON to display on screen cursors.
When Enabled, two cursors are displayed using dashed vertical lines. Cursors
are 1 and 2. Also shown is delta- T and 1/delta T. Use the mouse or touch
screen to move the cursors.
Zoom & Pan Available selections are:
• Time
• CH A
•
CH B
RUN / STOP Acquisition The Green Run button is location in the lower left corner. A Stop button is
located right next to it. The Stop button will be enabled while an acquisition is
in progress. The acquisition status is shown to the right of the Stop button as
either:
•
RUNNING
• WAITING TRIGGER
•
STOPPED
Acq. Mode Available selections are SINGLE MODE or REPEAT MODE
TRIGGER Trigger Modes Available Trigger mode selections are:
•
UPDATE PHASE CROSSING
• OUTPUT ENABLE
• OUTPUT DISABLE
• FREQUENCY CHANGE
•
VOLTAGE RMS CHANGE
• VOLTAGE DC CHANGE
• PHASE CHANGE
•
WAVEFORM CHANGE
•
INTERHARMONIC CHANGE
Position The trigger position can be set from 0% of vertical scale (left) to 100% of
vertical scale (right). The trigger position is indicated using a yellow diamond
on the time axis.
TIME BASE
Time/div Available time base settings range from 10 sec/div to 20 µsec/div. The
acquisition window is a function of this setting and the selected sample window
size.
OFFSET Trigger Offset Trigger offset time and be set from 0 msec to 99,999,999,999,999,980,000
msec
MEMORY DEPTH
No of Samples No samples acquires can be set from 100 Samples to 1M Samples
SAVE Image Saves Scope Image to PNG image file. Destination is browser default download
directory.
Note: Only the waveform display area of the browser window is saved. To save the entire
screen, including all scope settings, use a screen capture utility instead.
Data Saves scope data to CSV File. Destination is browser default download
directory.