Omron CP1L-EL20DR-D, Руководство по эксплуатации

Страница: 767 / 856

733
Auxiliary Area Allocations by Address Appendix D
A572 03 Send
Request
Switch
(Socket 3) Send processing executed when
socket service request switch 3 is
turned ON. (The protocol (TCP/UDP)
is determined when the socket is
opened.) Unit turns OFF switch 3
when send processing has been
completed. ON: Request
send
OFF: Finish
send --- Cleared When the
data is
sent, the
bit will
OFF. ---
04 Receive
Request
Switch
(Socket 3) Receive processing executed when
socket service request switch 3 is
turned ON. (The protocol (TCP/UDP)
is determined when the socket is
opened.) Unit turns OFF switch 3
when receive processing has been
completed. ON: Request
receive
OFF: Finish
receive --- Cleared When the
data is
received,
the bit will
OFF. ---
05 Close
Request
Switch
(Socket 3) Close processing executed when
socket service request switch 3 is
turned ON. (The protocol (TCP/UDP)
is determined when the socket is
opened.) Unit turns OFF switch 3
when close processing has been
completed. ON: Request
close
OFF: Finish
close --- Cleared When
socket is
closed,
the bit will
OFF. ---
A580 00 to 03 FB Commu-
nications
Instruction
Retries
Automatically stores the number of
retries in the FB communications
instruction settings specified in the
PLC Setup. 0 to F hex --- Cleared Written at
start of
operation
A581 All FB Commu-
nications
Instruction
Response
Monitoring
Time Automatically stores the FB commu-
nications instruction response moni-
toring time set in the PLC Setup. 0001 to FFFF
hex (Unit: 0.1
s; Range: 0.1
to 6553.5)
0000 hex: 2 s --- Cleared Written at
start of
operation ---
A598 00 FPD Teach-
ing Bit Turn this bit ON to set the monitoring
time automatically with the teaching
function.
While A598.00 is ON, FPD(269)
measures how long it takes for the
diagnostic output to go ON after the
execution condition goes ON. If the
measured time exceeds the monitor-
ing time, the measured time is multi-
plied by 1.5 and that value is stored
as the new monitoring time.
(The teaching function can be used
only when a word address has been
specified for the monitoring time
operand.) ON: Teach
monitoring time
OFF: Teaching
function OFF Cleared Cleared --- ---
A600 to
A603 All Macro Area
Input Words Before the subroutine specified in
MCRO(099) is executed, the source
words for the subroutine are trans-
ferred to A600 through A603 (input
parameter words). Input data:
4 words Cleared Cleared --- ---
A604 to
A607 All Macro Area
Output
Words After the subroutine specified in
MCRO(099) has been executed, the
results of the subroutine are trans-
ferred from A604 through A607 to
the specified destination words (out-
put parameter words). Output data:
4 words Cleared Cleared --- ---
Addresses Name Function Settings Status
after
mode
change
Status at
startup
Write
timing
Related
Flags,
Settings
Word Bits