Omron CP1L-EL20DR-D, Руководство по эксплуатации

Страница: 839 / 856

805
Appendix I
Ethernet Network Parameters
Parameter Value Description
Hold timer 18 s The hold timer is used for active open processing of TCP sockets.
An ETIMEDOUT error will occur if connection is not completed within
18 s.
Resend timer 3 s The resend timer is used to monitor completion of reception of arrival
confirmations when transferring data via socket services. If the timer set-
ting is exceeded before arrival confirmation is received, data is resent.
Resends are performed through the 12th timeout (3 s).
An ETIMEDOUT error will occur after the 12th timeout.
2MSL timer 120 s The 2MSL timer starts at the TCP socket that first closes the socket and
will run for 120 s in the TIME_WAIT status.
ARP timer 20 min/5 s If a complete ARP table entry (with an Ethernet address) is not referred
to for 20 minutes, it is removed from the table.
An incomplete ARP table entry (no response yet returned to the ARP
request) is removed from the table after 5 seconds.
Window size 2,144 bytes The initial value of the maximum capacity used to control the conver-
gence of TCP sockets. Actually, the node negotiates with the remote
node and uses the smaller of the values for the two nodes. The window
size will fluctuate with the available space in the TCP reception buffers of
the remote node when processing communications.
Segment size (MSS) 536 bytes TCP data is separated into 536-byte units
TTL (Time to Live) 30 30