background image

LCD PROJECTOR LENS

MODEL NO. LNS-W01Z / LNS-T01Z

LENS REPLACEMENT 
AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of
cabinet.  Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installation Manual corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector.  Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.

TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL

Refer to the Installation Manual corresponding to your projector.  
(See the chart below.)

Type of the Cabinet

Reference Installation Manual

Refer to this manual.

Refer to the Installation Manual

supplied with the Projector.

Other than the above cabinet

design.

Содержание LNS-T01Z

Страница 1: ...ion Manual corresponding with your projector When installing or replacing the lens make sure the Lens Model No matches with your projector Refer to the catalog or contact your sales dealer for the proper Lens Model No TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL Refer to the Installation Manual corresponding to your projector See the chart below Type of the Cabinet Reference Installation ...

Страница 2: ...ely The lens cover is on the lens for protection Be sure to replace the lens cover before installation When installing or replacing the lens be careful not to stain scratch or damage the lens After installing or replacing the lens be sure to check the following for safety 1 Check the lens is securely fixed by 4 screws 2 Check no wiring is tangled on the gear of lens motor or the other mechanical p...

Страница 3: ...lock sheet in the same position as the removed cover plate has been placed Two screws are not used 4 REMOVE THE COVER PLATE OF THE LENS COVER See figure 2 LENS MOTOR LEAD CONNECTOR K16B D D D D B A LENS MOTOR Fig 3 Figure shown inside of the cabinet REMOVE THE LENS See figure 3 1 Remove the connector K16B of the circuit board 2 Loosen the A B wire holder and remove the lens motor lead 3 Remove scr...

Страница 4: ...cture slide the picture obtain cor rect focus then lock the lens by Focus Lens Lock screw at this step 1 Insert the upper part lens cover and fix them with screws A 4 screws 2 Insert the lower part lens cover and fix them with screws B 2 screws 5 LENS MOUNTING BRACKET ATTACHED DRIVER FOCUS LENS LOCK SCREW UPPER LENS COVER LOWER LENS COVER A B Fig 4 Fig 5 Fig 6 When in install the both upper and lo...

Отзывы: