background image

LENS REPLACEMENT AND INSTALLATION PROCEDURE

1. Remove screws A (2 screws).

2. Pull down the lower lens cover while pushing

the part D, then remove it.

3. Remove screws B (2 screws).

4. Remove screws C (2 screws) and remove

upper lens cover.

1

A

Fig-1

Fig-2

IN CASE OF MODEL WITHOUT LENS

Remove 2 screws and pull down the plate.

2

UPPER LENS COVER

LOWER LENS COVER

C

B

D

D

COVER PLATE

REMOVE THE LENS COVER. (See figure-1)

(At the step

, insert the light-block sheet in

the same position as the removed cover plate
has been placed. Two screws are not used.)

4

REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)

LENS
MOTOR LEAD

CONNECTOR “ K16B”

(D)

(D)

(D)

(D)

B

A

LENS MOTOR

Fig-3

Figure shown inside of the cabinet.

REMOVE THE LENS. (See figure-3.)

1. Remove the connector “K16B” of the

circuit board.

2. Loosen the A, B wire holder and

remove the lens motor lead.

3. Remove screws D (4 screws) which

fastens the lens and remove the lens.

IN CASE OF MODEL WITH LENS

A

Set the light-block
sheet, so that the
large rounder side is
set over the lens.

Perform the steps 

to 

for lens replacement and installation.

5

1

SCREWS

Содержание LNS-T01Z

Страница 1: ...ion Manual corresponding with your projector When installing or replacing the lens make sure the Lens Model No matches with your projector Refer to the catalog or contact your sales dealer for the proper Lens Model No TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL Refer to the Installation Manual corresponding to your projector See the chart below Type of the Cabinet Reference Installation ...

Страница 2: ...ely The lens cover is on the lens for protection Be sure to replace the lens cover before installation When installing or replacing the lens be careful not to stain scratch or damage the lens After installing or replacing the lens be sure to check the following for safety 1 Check the lens is securely fixed by 4 screws 2 Check no wiring is tangled on the gear of lens motor or the other mechanical p...

Страница 3: ...lock sheet in the same position as the removed cover plate has been placed Two screws are not used 4 REMOVE THE COVER PLATE OF THE LENS COVER See figure 2 LENS MOTOR LEAD CONNECTOR K16B D D D D B A LENS MOTOR Fig 3 Figure shown inside of the cabinet REMOVE THE LENS See figure 3 1 Remove the connector K16B of the circuit board 2 Loosen the A B wire holder and remove the lens motor lead 3 Remove scr...

Страница 4: ...cture slide the picture obtain cor rect focus then lock the lens by Focus Lens Lock screw at this step 1 Insert the upper part lens cover and fix them with screws A 4 screws 2 Insert the lower part lens cover and fix them with screws B 2 screws 5 LENS MOUNTING BRACKET ATTACHED DRIVER FOCUS LENS LOCK SCREW UPPER LENS COVER LOWER LENS COVER A B Fig 4 Fig 5 Fig 6 When in install the both upper and lo...

Отзывы: