Molecular Devices ImageXpress Confocal HT.ai, Руководство пользователя

Страница: 194 / 256

ImageXpress Confocal HT.ai High-Content Imaging System User Guide
194 5084773 A
Installing the Disk Box
Note: Before you begin, follow the steps in the previous sections to remove the disk
box.
To install a disk box:
1. Use bulb duster to blow visible particulates off the disk box lens and window.
Do not use canned or compressed air as this can blow propellant onto the optics.
2. Install the new Confocal disk box into the empty disk box slot with the heads of the side
hex screws visible.
CAUTION!
Do not install the disk box backwards. If you do insert the disk box into the slot
backwards, the lens window is in the wrong location and you cannot tighten the
side hex screws.
Do not try to force the disk box into the slot. It is not possible to insert the disk
box upside-down.
3. Use the provided 4 mm hex key to tighten the two 4 mm side hex screws on the disk box
so that the box is secured from moving in any direction.
Note: Do not over tighten the hex screws. When properly tightened, the disk box
does not move up and down at all, nor slide in and out at all.
4. On the bottom of the disk box, plug in the ribbon cable.
Figure 8-3: Ribbon Cable and Cable Socket on the Bottom of the Disk Box
5. Place the disk box cover over the six screw holes and use the provided 2.5 mm hex key to
tighten the six 2.5 mm hex screws on the disk box cover enough to secure it on the
Confocal module housing.
6. Close the lower hinged side door.
7. Power on the system. See Powering On the Instrument on page 27 .
8. When the system powers on, use the MetaXpress software to perform a functional test of
the new disk box. See Testing the Disk Box on page 195 .