Mindray TE5, Руководство оператора

Страница: 266 / 323

17-2 System Maintenance
3. Remaining stains or dust attached to the surface of the cable or connector should be wiped
away using a cloth with a little soapy water and then air dried.
NOTE: Do not use a wet cloth to clean the probe connector.
 Cleaning the probe cable
1. Use a soft dry cloth to wipe away stains from the probe cable.
2. If the stains are difficult to remove, use a soft cloth dipped in a mild detergent and then let the
cable air dry.
 Cleaning holders
Tools: soft dry cloth, soapy water, soft brush
The surface of the power button should be cleaned with a soft dry cloth. Remaining stains should
be wiped away using a cloth with clean or soapy water (NOTE: the cloth should not be made too
wet, as this may cause electric shock) and the surface left to air dry.
1. Use a soft dry cloth to wipe away dust attached to the inside, outside and gaps in the probe
holder or gel holder. Use a soft brush to brush away dust or stains from the small intra-cavity
probe holder or its gap.
2. Remaining stains on the inside and outside of the holder should be wiped away using a cloth
with a little soapy water and then air dried.
 Cleaning the display
Tools: soft dry cloth, alcohol or neutral detergent.
Clean the system in power off status; or in power on status, tap in the top-right corner of the
screen and select to lock the system for 10 seconds.
Clean the display surface with a soft dry cloth. Remaining stains should be wiped away using a
cloth with a little neutral detergent or alcohol and then leave to air dry.
NOTE: Do not use chemical solvents, acid or alkaline solution to clean the display.
 Cleaning the cover
Tools: soft dry cloth, soapy water
Use a soft dry cloth to clean the system's cover. If the system is dirty, moisten the soft cloth with
mild soapy water, wipe away any stains, then air dry.
CAUTION:
Please clean all the system's dustproof covers periodically (once per
month). Failure to do so may result in system damage. Cleaning
times can be increased when the system is used in the open air or
somewhere more dusty.
NOTE: Use a soft brush to brush away dust attached to all visible sockets or interfaces (such
as probe sockets, sockets or interfaces in the IO panel and power supply panel). Do
not use a cloth and water.