Mindray TE5, Руководство оператора

Страница: 238 / 323

13-38 Probes and Biopsy
13.2.6 Verifying the Biopsy Guide Line
WARNING:
Prior to each biopsy procedure, be sure to verify the
guide line.
If the needle is not consistent with the guide line, DO
NOT perform the biopsy procedure.
NOTE: You can perform guide line verification on a single live B/C image, and all biopsy-
irrelevant operations are forbidden.
Adjusting the needle mark is necessary before each biopsy procedure.
1. Confirm that the needle-guided bracket has been installed securely in the correct position.
2. Prepare a container filled with sterile water.
3. Place the head of the probe in the sterile water and place a biopsy needle in the needle guide.
4. When the biopsy needle appears on the image, select [Biopsy] -> [Alignment] to align the
guide line with the biopsy needle.
Tap [Alignment] in the Biopsy menu to enter the Biopsy Verify menu.

Adjust the guide line position
Tap and drag the top dot on the line to change the position of the guide line.

Adjust the angle
Tap and drag the bottom dot on the line to change the guide line angle.

Save the verified settings
After the position and angle of the guide line are adjusted, tap [Save] and the system saves
the current guide line settings. If biopsy is entered again, the displayed Position and Angle are
the verified value.

Restore the factory default settings
Tap [Load Default] and the position and angle of the guide line are restored to the factory
default settings.

Exit biopsy verify status
Tap [Exit] and the system exits the guide line verification status.