IMO HD2 IP Series, Инструкция по эксплуатации

Страница: 42 / 361

HD2 IP55 High-ingress Protection Series Inverters Basic Operation Instructions
-30-
No. Name Instruction
2 Button
area
(4)
Function key
The function of function key varies with
the menu;
The function of function key is displayed
in the footer
(5)
(6)
(7) Short-cut key
Re-definable. It is defined as JOG function
by default, namely jogging. The function of
short-cut key can be set by the ones of
P07.12, as shown below.
0: No function ;
1: Jogging (linkage indicator (3); logic :
NO);
2: Reserved;
3: FWD/REV switch-over (linkage
indicator (3); logic: NC) ;
4: Clear UP/DOWN setting (linkage
indicator (3) logic: NC) ;
5: Coast to stop (linkage indicator (3);
logic: NC) ;
6: Switching running command reference
mode in order (linkage indicator (3); logic:
NC) ;
7: Reserved;
Note: After restoring to default values, the
default function of short-cut key (7) is 1.
(8)
Confirmation
key
The function of confirmation key varies with
menus, eg confirming parameter setup,
confirming parameter selection,
entering the next menu, etc.
(9) Running key
Under keypad operation mode, the
running key is used for running operation
or autotuning operation.
(10)
Stop/
Reset key
During running state, press the Stop/Reset
key can stop running or autotuning; this
key is limited by P07.04. During fault
alarm state, all the control
modes can be reset by this key.
(11)
Direction key
UP:
DOWN:
LEFT:
RIGHT:
UP: The function of UP key varies with
interfaces, eg shifting up the displayed
item, shifting up the selected item,
changing digits, etc;
DOWN: The function of DOWN key varies
with interfaces, eg shifting down the
displayed item, shifting down the selected
item, changing digits, etc;
LEFT: The function of LEFT key varies