IMO HD2 IP Series, Инструкция по эксплуатации

Страница: 300 / 361

HD2 IP55 High-ingress Protection Series Inverter
-280
Assume that the following response is returned:
01 03 02 00 03 F8 45
inverter
address
Read
command
Number
of bytes
Data content
CRC
The data content returned by the inverter is 0003H, which indicates that the inverter is in the
stopped state.
Example 2: View information about the inverter whose address is 03H, including "Type of
current fault" (P07.27) to "Type of last but four fault" (P07.32) of which the parameter addresses
are 071BH to 0720H (contiguous 6 parameter addresses starting from 071BH).
The command transmitted to the inverter is as follows:
03 03 07 1B 00 06 B5 59
inver
ter
address
Read
command
Start
address
6 parameters in total
CRC
Assume that the following response is returned:
03 03 0C 00 23 00 23 00 23 00 23
00 23 00 23 5F D2
From the returned data, we can see that all the fault types are 0023H, that is, 35 in the decimal
form, which means the maladjustment fault (STo)
9.4.8.2 Write command 06H examples
Example 1: Set the inverter whose address is 03H to be forward running. Refer to the table of
other function parameters, the address of "Communication-based control command" is 2000H,
and 0001H indicates forward running, as shown in the following figure.
Function Address Data description R/W
Communication-based
control command
2000H
0001H: Forward running
R/W
0002H: Reverse running
0003H: Forward jogging
0004H: Reverse jogging
0005H: Stop
0006H: Coast to stop
0007H: Fault reset
0008H: Jogging to stop
The command transmitted by the master is as follows:
03 06 20 00 00 01 42 28
inverter
address
Write
command
Parameter
address
Forward
running
CRC