IMO HD2 IP Series, Инструкция по эксплуатации

Страница: 349 / 361

HD2 IP55 High-ingress Protection Series
-329-
Table D-4 Parameters of the optional accessories
inverter model
Breaker rated
current (A)
Fast-acting fuse
rated current (A)
Contactor rated current
(A)
HD2IP-9.5A-43 20 20 18
HD2IP-14A-43 25 35 25
HD2IP-18.5A-43 32 40 32
HD2IP-25A-43 50 50 38
HD2IP-32A-43 63 60 50
HD2IP-38A-43 63 70 65
HD2IP-45A-43 80 90 80
HD2IP-60A-43 100 125 80
HD2IP-75A-43 125 125 98
HD2IP-92A-43
140 150 115
HD2IP-115A-43
180 200 150
HD2IP-150A-43
225 250 185
HD2IP-180A-43
250 300 225
HD2IP-215A-43
315 350 265
Note: Parameters of the optional accessories described in the preceding table are ideal values.
You can select accessories based on the actual market conditions but try not to use those with
lower values.
D.6 Reactors
When the voltage of the grid is high, the transient large current that flows into the input power
circuit may damage rectifier components. You need to configure an AC reactor on the input
side, which can also improve the current adjustment coefficient on the input side.
When the distance between the inverter and motor is longer than 50 m, the parasitic
capacitance between the long cable and ground may cause large leakage current, and
overcurrent protection of the inverter may be frequently triggered. To prevent this from
happening and avoid damage to the motor insulator, compensation must be made by adding
an output reactor. When a inverter is used to drive multiple motors, take the total length of the
motor cables (that is, sum of the lengths of the motor cables) into account. When the total length
is longer than 50 m, an output reactor must be added on the output side of the inverter. If the
distance between the inverter and motor is 50 m to 100 m, select the reactor according to the
following table. If the distance is longer than 100 m, contact IMO's technical support technicians.