Fuji Xerox Versant 80 Press, Руководство пользователя

Страница: 763 / 1019

Error Code
763
Pro
b
le
m
Solvin
g
22
003-702 [Cause] You tried to copy sides 1 and 2 of a document simultaneously specifying different
Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703 [Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704
[Cause] An error is found in the calibration pattern read, and the machine may be out of order.
[Remedy] Execute the calibration again. If the error is not still resolved, contact our Customer
Support Center.
003-705 [Cause] Copying is started before the machine exits the Power Saver mode and detects the
change for the tray size, when the paper size set in the tray that has been changed
during the Power Saver mode.
[Remedy] Cancel copying, and perform the operation for copying again.
003-750
[Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "Layout Adjustment" (P.160).
003-751 [Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
003-752
[Cause] A mix sized document was to be scanned at 600 dpi in Color/2 sided.
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
003-755 [Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-757 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document again.
003-760 [Cause] An incompatible combination of feature is specified for document scan conditions.
[Remedy] Confirm the selected options.
003-761 [Cause] The paper size of the tray selected for auto tray differs from the paper size of the tray
selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Tray Priority] settings.
003-763 [Cause] An error occurred when reading the Calibration Chart.
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.682).
003-795 [Cause] When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
[Remedy] Take one of the following measures:
z
Manually enter a reduction/enlargement ratio.
z
Change the paper size.
Error Code Cause and Remedy