Fuji Electric FRENIC-Ace series, Руководство пользователя

Страница: 639 / 788

11.9 Power Regenerative PWM Converters, RHC Series
11-35
SE
LEC
TI
N
G
P
E
R
IPH
ER
AL
E
Q
U
IPM
E
N
T
Chap 1
1
[ 2 ] Common specifications
Item Specifications
Contr
ol
Control method AVR constant control with DC ACR minor
Running/Stopping Starts rectification when the converter is powered ON after connection.
Starts boosting when it receives a run signal (terminals [RUN] and [CM] short-circuited or a
run command via the communications link).
After that, the converter is ready to run.
Running status signal Running, power running, regenerative operation, ready-to-run, alarm output (for any alarm),
etc.
CT/VT switching Switching between CT and VT modes.
CT: 150% of overload rating for 1 min
VT: 120% of overload rating for 1 min
Carrier frequency Fixed to high carrier frequency
Input power factor 0.99 or above
Restart after
momentary power
failure
Stops the gates (boosting) when the voltage level reaches the undervoltage level if a
momentary power failure occurs, and the converter can automatically restart after the power
recovers.
Power limiting control Controls the power not to exceed the preset limit value.
Indi
cati
on
Alarm display
(Protective functions)
AC fuse blown, AC overvoltage, AC undervoltage, AC overcurrent, AC input current error,
input phase loss, synchronous power supply frequency error, DC fuse blown, DC overvoltage,
DC undervoltage, charge circuit fault, heat sink overheat, external alarm, converter internal
overheat, overload, memory error, keypad communications error, CPU error, network device
error, operation procedure error, A/D converter error, optical network error, IPM error
Alarm history Saves and displays the most recent 10 alarms.
Saves and displays the detailed information of the trip cause for the previous alarm.
Monitor Displays input power, input current in RMS, input voltage in RMS, DC link bus voltage and
power supply frequency.
Load factor Allows the user to measure the load factor with the keypad.
Language Allows the user to check and modify function codes in any of the three languages--Japanese,
English or Chinese.
Charging lamp Lights when the DC link bus capacitor is charged.