Fuji Electric FRENIC-Ace series, Руководство пользователя

Страница: 111 / 788

3.4 Programming Mode
3-17
O
PE
R
AT
IO
N
U
SI
N
G
T
H
E K
EY
PAD
Chap 3
■
Selecting menus to display
The menu-driven system allows you to cycle through menus. To cycle through necessary menus only for simple
operation, use function code E52 that provides a choice of the display modes as listed Table 3.4-2.
The factory default (E52 = 0) is to display three menus--Menu #1 “Data Setting,” Menu #7 “Data Copying,” and
Menu #0 “Quick Setup,” allowing no switching to any other menu.
Table 3.4-2 Keypad Display Mode Selection – Function Code E52
Data for E52 Mode Menus selectable
0 Function code data setting mode (factory default)
Menu #1 “Data Setting”
Menu #7 “Data Copying”
Menu #0 “Quick Setup”
1 Function code data check mode
Menu #2 “Data Checking”
Menu #7 “Data Copying”
2 Full-menu mode Menus #0 through #8
Press the key to enter Programming mode and display menus. While cycling through the menus with
the / key, select the desired menu item with the key. Once the entire menu has been cycled
through, the display returns to the first menu item.
3.4.1 Setting up function codes “Data Setting:
!f__
through
!o__
”
Menu #1 “Data Setting” (
!f__
through
!o__
) in Programming mode allows you to configure all function codes.
(
!o
is displayed only when the option is installed.)
To use “Data Setting,” you need to set function code E52 to “0” (Function code data setting mode) or “2” (Full-menu
mode).
Figure 3.4-1 shows the menu transition and the function code data change procedure in “Data Setting.”
Figure 3.4-1 Menu Transition and Function Code Data Change Procedure in Menu #1 “Data Setting”