FATEK SD3 Series, Инструкция по эксплуатации, Страница: 54 / 396

2
3. Preparation
SD3 Series Instruction Manual
1. Installation
Ensure that the environments for installation and operation
meet the requirements specified in this document.
Should you use the product in conditions different from the specifications, please
contact us.
■ Do not install the product where it could be directly exposed to direct sunlight.
■ Be sure to install each amplifier inside a control panel.
■ Install the product in an environment free from humidity and ingress of water and oil such as cutting oil and oil mist.
■ Never use the product in ambient air of explosive or flammable gases, chloride, acidic or alkaline corrosive
ambiance such as sulfur dioxide, chlorine, ammonia and so on.
■ Use the product in an environment free from dust, iron dust, and chips.
■ Do not use the product near locations exposed to high temperatures, continuous vibrations, or excessive shock.
■ The control power and the host control device must share one power supply (24 VDC).
■ When performing maintenance, be sure to turn off the circuit breaker of the main power in advance.
■ Be aware of the residual voltage in the amplifier remaining for 5 minutes after the main power shut off.
■ Never attempt to replace a fuse.
■ The amplifier of 750 W or more has a cooling fan on the right side.
Do not touch or block the air vent of the amplifier. Do not place objects which would block the air vent.
SD3 Series Amplifiers are not waterproof.
The protective enclosure rating of motors depends on the rated output.
50 W to 750 W : IP65
1 kW to 2 kW : IP67
(except for the shaft output component and the connectors)
Installation and Operating Environment
Precautions
Dust-proof and Waterproof
1. Installation