FATEK SD3 Series, Инструкция по эксплуатации, Страница: 46 / 396

26
2. Specifications
SD3 Series Instruction Manual
3. Amplifier
Functions Specifications
Item Specifications
Pulse Input
Control input
Servo ON, alarm reset, command input not allowed, emergency stop, deviation counter clear,
2-stage torque limit, CCW/CW run not allowed, ABS data demand, homing start
Control output
Alarm status, servo status, servo ready, under torque limit, brake release, positioning
complete, motion complete, alarm, dynamic brake release, ABS data transmitting,
homing complete
Maximum command pulse
frequency
RS-422 differential: 4 Mpps
Open-collector: 200 kpps
Input pulse signal form
(*7)
pulse and direction (PLS + DIR), quadrature phase difference pulse (A-phase + B-phase),
positive or negative pulse (CCW + CW)
Command pulse-paired ratio
ratio A/B: 1/1,000 < A/B < 1,000
Setting range A: 1 to 65,535, Setting range B: 1 to 65,535
Internal Position
Control input
Servo ON, alarm reset, deviation counter clear, motion start
point selection 16, home position sensor input, homing start
Control output
Alarm status, servo status, servo ready, under torque limit, brake release,
homing complete, motion complete
Operation mode Point table, communication operation
Smoothing filter FIR Filter
Damping control Enabled
Position Control Mode
Item Specifications
Analog Velocity
Control input
Servo ON, alarm reset, command input inhibit (zero torque command),
2-stage torque limit, CCW/CW run prohibited
Control output Alarm status, servo status, servo ready, under torque limit, brake release
Speed command input Input voltage: −10 V to +10 V (max speed is reached at ± 10 V
Internal Velocity
Control input
Servo ON, alarm reset, start 1 (CCW), start 2 (CW), 8-stage speed command
2-stage torque limit
Control output Alarm status, servo status, servo ready, under torque limit, brake release
Smoothing filter IIR Filter, FIR Filter
Velocity Control Mode