FATEK SD3 Series, Инструкция по эксплуатации, Страница: 238 / 396

96
5. Setting Parameters
SD3 Series Instruction Manual
5. Parameters
No. 720.0
No. 740.0
to
No. 1020.0
Internal Position:
Point table
Command method (*)
Settings Default Characteristics
0, 1 0
Function
Use
Select the command method for point table.
Settings Command Method Position to be set
0 Absolute value Target position
1 Relative value Shit amount from the current position to the target position
Common Position Control Pulse Train Command Position Control Internal Command
Velocity Control Analog Command Velocity Control Internal Command Torque Control Analog Command
Communication Operation Mode Operation Control
Alarm Detection Tuning Homing
Torque Limit Deceleration Stop and so on Vibration Control
Switch Selection Numeric Value
Control Power Cycle 2-Byte Data 4-Byte Data
*) See the Point Table Parameter List to look up a point number and its corresponding parameter numbers.
Page 102
- -