FATEK SD3 Series, Инструкция по эксплуатации, Страница: 371 / 396

9
9
9. Appendices
SD3 Series Instruction Manual
Appendices
1. Absolute System
1. Absolute System
Initializing Encoder with "Servo Studio"
Start Encoder Initialization
N
YES
NO
Y
N
Y
Servo Studio
Operation Manual
N Y
Turn on the control power and start communicating
with the amplifier by using Servo Studio .
1. Under the Auxiliary function tab, click Encoder
2. Click on Get Encoder Status.
5. Click .
6. Cycle the control power.
3. Check one of the boxes.
4. Click .
Until checking the boxes, the Clear encoder
button does not work.
Step 1
Step 2
Step 3A
Is the target axis near
the home position?
Turn the servo ON, then move it
by host command, inching or jogging.
Setting
Auxiliary Function Mode
5
Confirm
Step 3B
Connect all cables and wires.
（Connect the battery to the encoder as well.）
Can you move it close
to the home position manually?
Manual
motion
Command Input
motion.
① Set Parameter No.257.0 to 1 or 2.
Multi-turn counter overflow detection
１ : Disable
２ : Enable
② Save the parameters and cycle power.
If you shut down the control power without saving,
the setting changes will not take effect.
After shutting off the control power, wait for at least
5 seconds before turning the power back on.
Did you disconnect
any cable or battery
before reboot?
U til h ki th b
Clear encoder
k .
Yes
6HUYR6WXGLR
6HUYR6WXGLR
6HUYR6WXGLR
6HUYR6WXGLR