FATEK SD3 Series, Инструкция по эксплуатации, Страница: 215 / 396

73
5
Setting Parameters
5. Setting Parameters
SD3 Series Instruction Manual
5. Parameters
5. Parameters
No. 233.0
Deceleration Stop:
Method (when alarm is on)
Settings Default Characteristics
0 to 7 2
Function
Use
Select a deceleration stop method in case of alarm while motor is in motion.
Each alarm group uses a different stop method.
(*1)
Settings
Stop method
Group ①
Group ②
(*2)
, ③ , ④ Group ⑤
0
1
2
3
4
5
6
7
*1) Alarms are categorized into five groups.
*2) When Deceleration stop: Method (No.224.0) = 0 (Disable), the motor will be stopped by the group ① method.
After the amount of time specified by Deceleration stop: Operating time (No.228.0) elapses, the motor will be stopped by the group ①
method.
Free run Quick stop Short brake Dynamic brake
Alarm
No.
Alarm Name and Group
0 System error
④
1 EEPROM data error
④
2 Product code error
④
4 Overspeed error
⑤
5 Speed deviation error
⑤
6 Position deviation error
⑤
7 Overload error
④
8 Command overspeed error
⑤
9
Encoder pulse
output frequency error
④
10
Positioning command overflow error
/Homing failure
⑤
11
Encoder error
(multi-turn counter overflow)
⑤
12 Overheat error
⑤
14 Overvoltage error
①
15
Power supply error
(primary circuit power)
⑤
Alarm
No.
Alarm Name and Group
16 Encoder error (response data)
③
17 Encoder error (no response)
③
18 Encoder error (circuitry)
③
19 Encoder error (communication)
③
20 Encoder error (multi-turn data)
③
21 Encoder error (voltage drop)
③
22 Voltage error (control power)
②
23 Switch circuitry error
①
24 Overcurrent error
①
25 Inverter error 1
①
26 Inverter error 2
①
27 Current sensor error
①
28 Encoder error (overheat)
⑤
29 Voltage drop (inside the amplifier)
①
-