Fairplay ZX, Руководство пользователя

Страница: 56 / 168

REAR SUSPENSION
Read section A and B completely prior to operation or repair of golf car
D-4
remove wires from the motor
。
(See safety procedures in SAFETY section of this manual). The shorting of motor wires could
cause an explosion.
Before any electrical service is performed on PDS model vehicles, the
“Run-Tow/Maintenance” switch must be placed in the “Tow/Maintenance” position.
If a power wire (battery, motor or controller) is disconnected for any reason on the PDS model
vehicle, the “Run-Tow/Maintenance” switch must be left in the “Run” position after the circuit is
restored.
Turn the key switch to “OFF” position, disconnect the negative pole (-) cable from the battery, and the
electrical system is thus powered off.
Fig. D1: Disconnect Battery Cable
Remove the wires to the motor, being careful to prevent the axle assembly (6) from rotating, remove the
bottom shock mounting hardware and the springs from the rear axle as detailed elsewhere in this
section.
Disconnect brake cables at rear wheel and axle bracket.
The rear axle and motor assembly can now be lifted from the jack stands and lowered to the floor.
To remove the rear axle assembly will require the use of an overhead hoist that can support the
motor. The position of the motor will cause the rear axle assembly to rotate when the 'U' bolts (7)
are removed. If no crane is available, allow a second person to maintain the motor in appropriate
position. With the leaf springs removed, both persons can lift the entire assembly from the jack
stands and lower it to the floor.
Disconnect
power