Fairplay ZX, Руководство пользователя

Страница: 151 / 168

ACCESSORY WIRINGS
Read section A and B completely prior to operation or repair of golf car
L-4
POWER SUPPLY
Tool List Qty. Required
DVOM.................................................................1
1. CHECK FOR LOOSE OR BARE WIRES
Check for loose wires at each terminal connection and for worn insulation or bare wires touching the
frame. Bare wires may cause a short circuit.
If any DVOM readings indicate a faulty wire, it is recommended that the condition of the terminals and
wire junction be examined. A faulty wire should be replaced with one of the same gauge and color and
wired between the correct components and wire tied to the harness bundle. The faulty wire should be cut
back close to the harness and the ends protected with vinyl electrical tape.
2. CHECK FOR BATTERY CONDITION
Check for adequate battery volts (nominal 12 VDC) by setting DVOM to 20 VDC range and place the red
probe (+) on the battery post with the green wire attached. Place the black probe (-) on the battery post
with the black wire attached. A reading of 11 VDC or greater indicates adequate battery condition. No
reading indicates (a) a poor connection between the probes and the battery terminals; (b) a faulty DVOM.
A voltage reading below 11 volts indicates poor battery condition and the vehicle should be recharged
before proceeding with the test.
Due to the resistance of the wires involved within the harness, voltage readings may be
somewhat lower than battery voltage. A reading of 1 volt below battery voltage is acceptable.
3. CHECK POWER WIRE
Firmly attach the black probe (-) to the battery post with the black wire attached and the red probe (+) to
the red terminal at the fuse block. A reading of battery voltage indicates that the power wire is in good
condition.
The red wire supplies power to the entire fuse block.
4. CHECK FUSE
Place the red probe (+) to each wire terminal on the fuse block. A reading of battery voltage indicates
that the fuse is in good condition. No reading indicates a faulty fuse; replace with a good 20 amp fuse.