epiphan Pearl-2 Rackmount, Руководство пользователя, Страница: 115 / 497

Pearl-2 User Guide Configure a static IP address
2. From the Configuration menu, select Network . The Network configuration page opens.
3. Choose No from the Use DHCP drop-down and enter your networking information in to the required
fields. Click Apply when you're done.
Table 19 Static IP Address Fields
Label Description
Use DHCP
Select Yes to dynamically obtain an IP address at boot up or select No to use the
configured static IP address.
IP Address
The internet protocol address (IP Address) to assign. Obtain this from your network
administrator. Pearl-2 supports IPv4 addresses. It does not support IPv6 addresses.
Network Mask
Also called the subnet mask, this value denotes a range of IP addresses. Obtain this
from your network administrator, from another computer on the same subnet, or
calculate the value using an online subnet calculator.
Default gateway
The network node that serves as an access point to the rest of the network. This value
cannot be blank unless you are using DCHP. Specify the system’s IP address if you
don’t have a default gateway on your network.
DNS Server
The domain name system server (DNS server) translates human-readable hostnames
into corresponding IP addresses. Specify the system’s IP address if you don’t have a
DNS server on your network. This value cannot be blank unless you are using DHCP.
MTU Size
The maximum transmission unit (MTU) specifies the maximum packet size for
transfer on the network. The default value is 1500, which is the largest value allowed
102