Section 10 — Wave Data Parameters
ASR-10 Musician’s Manual
20
Command/LFO Page
Command/LFO Page (Data Commands)
CMD
CLEAR DATA
LFO
Press Command / LFO / 0
Use this command when you want silence as part of the WaveSample. Use the “start and end”
addresses to select the section of WaveSample data you want to clear.
Before:
After:
START
ADDR
END
ADDR
• Select CLEAR DATA. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
CMD
COPY DATA
LFO
Press Command / LFO / 1
COPY DATA enables you to copy a section of wave data from one WaveSample and paste it over
part of another WaveSample, replacing the data that was previously there. Use the “start and
end” addresses, to copy wave data from a source to a destination. In fact, source and destination
could be the same WaveSample, or the destination WaveSample could be in a different
instrument.
Before:
After:
START
ADDR
END
ADDR
Second WaveSample
DEST
ADDR
First WaveSample
DEST
ADDR
Second WaveSample
• Select COPY DATA. Press Enter•Yes.
• Select FR INST=## L=## WS=##. Scroll to START ADDR=## (##).
• Scroll to END ADDR=## (##). Scroll to TO INST=## L=## WS=##.
• Scroll to DEST ADDR=## (##). Press Enter•Yes to complete the command (or Cancel•No to
abort the procedure).
