Section 10 — Wave Data Parameters
ASR-10 Musician’s Manual
22
Command/LFO Page
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
CMD
INVERT DATA
LFO
Press Command / LFO / 4
This command inverts the phase of the selected wave data. This is the equivalent of playing the
WaveSample upside down, with all frequency peaks becoming valleys and vice versa. If you’re
performing advanced WaveSample manipulation it is sometimes helpful to invert the phase of a
signal for the purposes of cross fading. This will sometimes produce a smoother cross fade point.
Before:
START
ADDR
END
ADDR
After:
• Select INVERT DATA. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
CMD
ADD DATA
LFO
Press Command / LFO / 5
This command is similar to COPY DATA, except it adds a section of the wave data from one
WaveSample into part of another WaveSample, creating a composite of the two, according to the
source and destination ranges. It could be the same WaveSample, or two different ones. When
PREVENT CLIPPING is enabled, the ASR-10 (if necessary) will scale down the destination and
source data, so the added data doesn’t result in clipping.
Before:
After:
1st WaveSample
START
ADDR
END
ADDR
2nd WaveSample
2nd WaveSample
DEST
ADDR
• Select ADD DATA. Press Enter•Yes.
• Select FR INST=## L=## WS=##. Scroll to START ADDR=## (##).
• Scroll to END ADDR=## (##). Scroll to TO INST=## L=## WS=##.
• Scroll to DEST ADDR=##(##). Scroll to PREVENT CLIPPING=(NO/YES). Press Enter•Yes.
• The display reads KEEP=OLD NEW. Press Enter•Yes to complete the command (or
Cancel•No to abort the procedure).
