Section 6 — Effect Parameters
ASR-10 Musician’s Manual
8
Edit/Effect Parameters
BUS1 and BUS2 parameters can be routed into the effect with different Dry/Wet mixes.
Gated Reverb with a High Retrigger Threshold
Trigger
Retrigger
Signal
Hold Time
Level
Time
Attack Time
Release
Gated Reverb with a Low Retrigger Threshold
Trigger
Retrigger
Signal
Level
Time
Hold Time
Hold Time
Hold Time
Hold Time
Hold Time
Hold Time
Hold Time
Hold Time
Hold Time
The parameters available for the Gated Reverb algorithm are:
ATTACK TIME
Range:
1ms to 10.0s
This parameter sets the ATTACK TIME of the gated reverb once the incoming signal has reached
the trigger level. Generally the attack should be short and not set longer than the HOLD TIME.
This parameter should not be used to achieve a reverse reverb envelope, because here the attack
volume increases whereas in the Reverse Reverb the attack volume accelerates.
HOLD TIME
Range:
1ms to 10.0s
This parameter sets the amount of time that the reverb will hold after the retrigger and before the
release. The HOLD TIME will begin again if retriggered.
DECAY TIME
Range:
0.2 to 100.0 sec.
This parameter controls the amount of time it takes for the reverberation to decay.
RELEASE TIME
Range:
1ms to 10.0s
This parameter sets the amount of time after the HOLD TIME has elapsed for the gated reverb to
shut down. Generally these times are very short.
