Section 10 — Wave Data Parameters
Command/LFO Page
21
CMD
REPLICATE DATA
LFO
Press Command / LFO / 0
The REPLICATE DATA command is used to append a section of wave data to itself as many
times as will fit within the original WaveSample size. The replicated data will fill the remaining
area of the WaveSample that lies after the END ADDR. Set the data range with the “start and
end” addresses.
WS
WE
LE
LS
REPLICATE DATA
first append
0%
100%
WaveSample Memory
WS = Wavesample Start
LS = Loop Start
LE = Loop End
WE = Wavesample End
source start
source length
second append
last append
• Select REPLICATE DATA. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##). Press Enter•Yes.
• The display reads KEEP=OLD NEW. Press Enter•Yes to complete the command (or
Cancel•No to abort the procedure).
Note:
When STEREO LAYER LINK= ON, this command will be simultaneously performed on the
corresponding WaveSample in the companion layer.
CMD
REVERSE DATA
LFO
Press Command / LFO / 3
The REVERSE DATA command takes the wave data in the specified range and turns it around
backward, so that the last sample becomes the first one, the next-to-last sample becomes the
second, and so on. It has the same effect as playing the WaveSample backward.
Before:
After:
START
ADDR
END
ADDR
• Select REVERSE DATA. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
