ECKELMANN Case Controller UA 4 E Series, Инструкция по эксплуатации

Страница: 179 / 466

Firmware V3.13 21.04.2021 179/466
8.3 Remote control via a terminal
For the remote control of a controller, it makes no difference whether this is done with a system centre (A),
a store computer or with an operator terminal (B) as the user interfaces on the terminals are almost identical
and the same functions are available. See chapter
Calling the controller menu via remote control for details
about remote control.
The system centre only emulates the "hardware front" of its "store computer" predecessor or of the operator
terminal by software on its touchscreen which is demonstrated by the following comparison between the
terminals of the Virtus 5, CI 5x00, CI 4x00 und CI 3x00 / AL 300:
(1) Virtus 5, CI 5x00, CI 4x00 und CI 3x00 / AL 300: "Alarms and messages" button in the main menu for
display of whether alarms are pending. Alarms are acknowledged in the "alarm list".
CI 3x00 / AL 300:Red LED signal lamps to indicate whether alarms are pending.
(2) Virtus 5, CI 5x00, CI 4x00 und CI 3x00 / AL 300: "Horn" button in the main menu for muting of the buzzer
and for reset of the AUX relay.
CI 3x00 / AL 300: Button for muting of the buzzer, for reset of the AUX relay* and for acknowledgement of
alarms.
(3) Display (4 lines x 20 characters) for display of the menu of the controller.
(4) ESC button
(5) Cursor buttons
(6) MODE button for, e.g. toggle upper case / lower case for text input.
(7) Alphanumeric keypad
(8) ENTER button (
↵
)
OnlyCI 3x00 / AL 300:
(9) On/Off button for, e.g. lighting
(10) Green LED signal lamp for status indicator whether the button is activated (then green) or deactivated.
Further details for the operation of a system centre, store computer or operator terminal can be found
in their operating manuals.
