Docomo FOMA N901IC, Руководство пользователя, Страница: 486 / 596

484
Data Comm
unication
1
Pull it out straight while pressing the
release buttons of the external connector
of FOMA USB connection cable.
2
Remove the FOMA USB connection cable
from the USB terminal of the PC.
3
Close the FOMA terminal’s external
connector cap.
Checking the Procedure
In packet communication, the connection is made through
a dial-up connection with Internet service providers or
LANs that support FOMA packet communication.
■ About the “CD-ROM for FOMA N901iC” provided
● The CD-ROM contains the communication setting file
(drivers), FOMA PC setting software and
FirstPassPCSoft.
● The N901iC Communication setting file is software
(driver) needed for connecting the FOMA terminal with
a PC via a FOMA USB Connection cable (optional) to
carry out packet communication. 64K communication
data transfer (OBEX). Installing the N901iC
Communication setting file embeds each driver into
Windows.
Using the FOMA PC setting software, you can easily
set up packet communication and 64K communication
and create a dial-up connection.
● Using FirstPass PC software allows you to set up
FirstPass (user certification) easily and therefore it will
be helpful for gaining authentication when you try
viewing FirstPass-compliant sites on the PC browser.
For details, refer to “FirstPassManual” (PDF format)
stored in the “FirstPassPCSoft” folder included on the
CD-ROM. You will need Adobe Reader (recommend
version 6.0 or higher) to view the “FirstPassManual”
(PDF format).
If the software is not installed on your PC, you can
download the latest version of the software directly from
the Adobe website. (Communication fees are charged
separately.) For details, refer to the Adobe website.
Flow Chart for completing the data communication setup
This section describes preparation to use packet
communication and 64K communication.
*1 : “mopera” is DoCoMo’s Internet connection service for which you do
not need to apply. We recommend that you set up communication
using “mopera” if you want to connect to the internet easily.
Setting the PC
This section describes the steps from connection to a PC
to installing of the N901iC communication setting file
(drivers).
Connecting the FOMA terminal to a PC
1
Connect the FOMA USB connection
cable to the PC USB terminal.
2
Start up Windows and insert the “CD-
ROM for FOMA N901iC” in the CD-ROM
drive of your PC.
Note
● Do not repetitively connect and disconnect the FOMA USB
connection cable. After you have connected and disconnected
once, wait for a while before doing so again.
P. 483
P. 485
P. 488
P. 490
P. 491
P. 493
P. 493 P. 499
P. 494
P. 495
P. 510
P. 512
・ Connect → P.494
・
Disconnect
→
P.495
Connect and disconnect
・ Connect → P.510
・
Disconnect
→
P.512
Connect and disconnect
・ mopera → P.490
・
Other providers
→
P.491
Set up
・ mopera → P.493
・
Other providers
→
P.493
Set up
・ Set up communication not
using the FOMA PC
setting software
→ P.499
Setting
Install PC/N901iC Communication setting file
(Driver)
・ Connect the PC with the FOMA terminal using a FOMA USB
connection cable.
→ P.483
・ Install the N901iC Communication setting file. → P.485
・
Enables you to use FOMA PC setting
software.
See “Installing the FOMA PC setting
software” (P.488)
<For 64K data
communication>
<For packet
communication>
<To set up the connecting destination
using FOMA PC setting software> <Not using FOMA PC
setting software>
Install the FOMA PC setting
software