5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
83
Display Parameters
Last User Whose
Password ls Set
Indicates the name of the user whose password was set most recently.
Password Strength Check
Indicates whether or not password strength checking is enabled.
Last Password Set Result
Indicates whether or not the preceding attempt to set a password was
successful. In the event that the attempt failed, the reason that it failed is
included.
SNMP Commands
In this section, the commands used in order to configure the Simple Network Management Protocol
(SNMP) on the switch are described. The user can configure the switch so that it acts as an SNMP agent,
which in turn allows it to communicate with SNMP managers on your network.
4-91
snmp-server
This command is used to set the name as well as the physical location of the switch, in addition to the
organization responsible for the network. The parameters
name
,
Loc,
and
con
may be a maximum of 255
characters in length.
Note:
If you wish to clear the snmp-server, then simply enter an empty string in quotes. For example,
entering snmp-server {sysname “ ”} will clear the system name.
snmp-server {community community | community-group community-group | contact con | enable
traps {bgp|linkmode|multiusers|stpmode|violation} | engineID {engine-id |default} | filter filter-name |
group group-name | host ipaddr ipv6addr hostname | location Loc | sysname name | user user | v3-
host v3-host | view view}
Parameters
community community
Select the SNMP community string (1-20 characters).
community-group
community-group
Select the group name to use when mapping an internal security name
for SNMP v1 and SNMP v2.
contact con
Select a system contact up to 255 characters in length.
enable traps
Select to enable SNMP Traps.
engineID engine-id
Select to specify the SNMP engine ID on a local drive.
filter filter-name
Select a name to specify a filter entry.
group group-name
Select a group name to configure a new SNMP group.
host ipaddr ipv6addr
hostname
Select a new recipient by entering the IPv4 or IPv6 address/hostname of
the SNMP notification host.
Содержание 5000 Series
Страница 1: ...Draft 1 2 1 ...
Страница 141: ...5000 Series Layer 2 3 Managed Data Center Switch CLI Reference Guide 135 ...
