D-Link 5000 Series, Справочное руководство CLI

Страница: 1069 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1063
Command Mode
IPv4 VRF Address Family Config
11-59 neighbor filter-list (IPv6 Address Family Config)
This command filters BGP to apply an AS-PATH access list to UPDATE messages received from or sent
to a specific neighbor. Filtering for IPv6 is independent of filtering configured for IPv4. lf an UPDATE
message includes both IPv4 and IPv6 NLRI, it could be filtered for lPv4 but accepted for IPv6 or vice
versa.
If you assign a neighbor filter list to a non-existent AS-PATH access list, all routes are filtered.
Use the no command to unconfigure neighbor IPv6 filter lists.
neighbor ip-address filter-list as-path-list-number {in | out}
no neighbor ip-address filter-list as-path-list-number {in | out}
Parameters
ip-address The neighbors lP address.
as-path-list-number Identifies an AS-PATH list.
in The AS-PATH list is applied to advertisements received from the
neighbor.
out The AS-PATH list is applied to advertisements to be sent to the
neighbor.
Default
The default is No Neighbor Filter Lists configured.
Command Mode
IPv6 Address Family Config
11-60 neighbor inherit peer (BGP Router Config)
To configure a BGP peer to inherit peer configuration parameters from a peer template, use the neighbor
inherit peer command in Router Configuration mode. Neighbor session and policy parameters can be
configured once in a peer template and inherited by multiple neighbors, eliminating the need to configure
the same parameters for each neighbor. Parameters are inherited from the peer template specified and
from any templates it inherits from. A neighbor can inherit directly from only one peer template.
Use the no command in Router Configuration mode to remove the inheritance.
neighbor {ip-address | ipv6-address [interface interface-name] autodetect interface interface-name
inherit peer template-name
no neighbor ip-address inherit peer template-name