D-Link 5000 Series, Справочное руководство CLI

Страница: 1077 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1071
This command configures BGP to use a local address as the IPv6 next hop when advertising IPv6 routes
to a specific peer. For IPv6, BGP uses an IPv6 address from the local interface that terminates the IPv4
peering session.
Use the no command to disable the peer as the next hop for the locally originated paths. After executing
this command, the BGP peer must be reset before the changes take effect.
neighbor ip-address next-hop-self
no neighbor ip-address next-hop-self
Parameters
ip-address The neighbor’s IP address.
Default
The default is Disabled.
Command Mode
IPv6 Address Family Config
11-70 neighbor password
Use this command to enable MD5 authentication of TCP segments sent to and received from a neighbor,
and configures an authentication key.
MD5 must either be enabled or disabled on both peers. The same password must be configured on both
peers. After a TCP connection is established, if the password on one end is changed, then the password
on the other end must be changed to match before the hold time expires. With default hold times, both
passwords must be changed within 120 seconds to guarantee the connection is not dropped.
Issue this command in Peer Template Configuration Mode to add it to a peer template.
Use the no command to disable MD5 authentication of TCP segments sent to and received from a
neighbor.
neighbor {ipv4-address | ipv6-address [interface interface-name] | autodetect interface Interface-
name} password string
no neighbor {ipv4-address | ipv6-address [interface interface-name] | autodetect interface
Interface-name} password
Parameters
ip-address The neighbor’s IPv4 address.
ipv6-address The neighbor’s IPv6 address.
interface interface-name If the neighbor's IPv6 address is a link local address, the local interface
must also be specified.
autodetect interface The routing interface on which the neighbors link local IPv6 address is