D-Link 5000 Series, Справочное руководство CLI

Страница: 23 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
17
Key Sequence Description
Ctrl-Z Returns user to root command prompt.
Tab, <SPACE> Yields command-line completion.
Exit Returns user to next lower command prompt.
? Opens list of available commands, keywords, or parameters.
Using CLI Help
To display the commands available in the current mode, enter a question mark (?) at the command
prompt.
(Routing)>?
enable Enter into user privilege mode.
help Display help for various special keys.
logout Exit this session. Any unsaved changes are lost.
ping Send ICMP echo packets to a specified IP address.
quit Exit this session. Any unsaved changes are lost.
show Display Switch Options and Settings.
telnet Telnet to a remote host.
To display available command keywords or parameters, enter a question mark (?) after each word you
enter.
(Routing) #network ?
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the router.
protocol Select DHCP, BootP, or None as the network config protocol.
In the event that the help output displays a parameter in angled brackets, you must replace the parameter
with an appropriate value.
(Routing) #network parms ?
<ipaddr> Enter the IP address.
In the event that there are no other command keywords or parameters, or in the event that any additional
parameters are optional, the following message will appear in the output:
<cr> Press Enter to execute the command.
A question mark (?) may also be entered after the user types one or more characters of a word should
the user wish to see a list of the available commands or parameters that begin with the letter(s)s, as
shown in the following example:
(Routing) #show m?
Mac-addr-table mac-address-t monitor